![]()
Typically, on a home network, the subnet mask is 255.255.255.0. Select the Use the following IP address option.Īssign the static IP address – for example, 10.1.2.220. Select the Internet Protocol Version 4 (TCP/IPv4) option.Ĭontrol Panel’s network adapter properties Right-click the network adapter and select the Properties option. Use these steps to assign a static IP configuration using Control Panel:Ĭlick the Change adapter settings option on the left navigation pane. WINDOWS 10 CANT CHANGE FILE DETAILS WINDOWSIf Command Prompt is not for you, it is possible to use Control Panel to change the IP settings on Windows 10. WINDOWS 10 CANT CHANGE FILE DETAILS HOW TOHow to assign static IP address using Control Panel ![]() As a result, you should start using the “NetTCPIP” networking module available in PowerShell instead. Microsoft is in the process of retiring netsh from Windows 10. Alternatively, you can open a website to see if the configuration works. WINDOWS 10 CANT CHANGE FILE DETAILS WINDOWS 10Windows 10 netsh command to set static IP addressĪfter you complete the steps, you can test the new configuration using the ping command (for example ping ) to see if the internet is working. In the command, replace Ethernet0 with your adapter’s name and 8.8.8.8 with an alternate DNS server address. Type the following command to set an alternate DNS server address and press Enter: netsh interface ip add dns name="Ethernet0" 8.8.8.8 index=2 In the command, make sure to change Ethernet0 with your adapter’s name and 10.1.2.1 with the DNS server address of the network. Type the following command to set a DNS server address and press Enter: netsh interface ip set dns name="Ethernet0" static 10.1.2.1 Change 10.1.2.220 255.255.255.0 10.1.2.1 with the device IP address, subnet mask, and default gateway address corresponding to your network configuration. In the above command, replace Ethernet0 with the name of your network adapter. Type the following command to assign a static IP address on Windows 10 and press Enter: netsh interface ip set address name="Ethernet0" static 10.1.2.220 255.255.255.0 10.1.2.1 Under the network adapter, note the name of the adapter as well as the following information in these fields: Type the following command to see your current networking configuration and press Enter: ipconfig /all ![]() Search for Command Prompt, right-click the top result, and select the Run as administrator option. Use these steps to set a static IP address on Windows 10 using Command Prompt: How to assign static IP address using Command PromptĪlthough using commands may be challenging for some users, this is one of the quickest ways to set a static IP address on Windows 10.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |